Compare · job: ceiling installation robots · stage: fit-out and finishes
Ceiling installation robots, side by side
Every tool on the record for ceiling installation robots: 2 robots, from Ceiling board installation robot (WORKROID, with Kajima) and Robo-Buddy, in alphabetical order. 2 carry an assessment of where they fit on a job and the catch. Each was read at the maker's own source, most recently on 10 November 2026.
ComparingAll 2 toolsChoose which
Show
Fact
RS-R550 · Robot · TMSUK Co., Ltd.Ceiling board installation robot (WORKROID, with Kajima)
RS-R923 · Robot · Shimizu CorporationRobo-Buddy
At a glance
What it doesA small mobile robot that lifts and fixes ceiling boards into a grid ceiling after a worker sets the job on a tablet. Part of a family of robots for hanging bolts, ceiling grid and boards.A two-armed robot that fits ceiling hanger bolts and backing members, then holds ceiling boards with one arm and screws them up with the other. It finds its working position by comparing the BIM model with the ceiling frame as built, and can also lay raised-floor pedestals and panels.
Who it's forCeiling and interior contractors on office buildings with system ceilings.Main contractors building suspended ceilings on large high-rise jobs.
The catchUsed on Kajima sites so far; no published sale or rental terms or specifications.Shimizu's own site robot: it is not sold or hired, and the maker publishes no payload, reach or output figures.
AssessmentReplaces one hard, repetitive job: drilling overhead, laying tiles, tying rebar, fixing boards, setting out. Robots built for one task. Early days: many are the makers' own services or pilots rather than machines you can buy, but this is where site work is heading. TMSUK's WORKROID lifts and fixes ceiling boards into a grid, used on Kajima sites so far. The catch: each does one job in set conditions, and almost none publish a price or output you can plan on.Replaces one hard, repetitive job: sanding and painting, tying the mat, cutting boards, fixing the ceiling, spraying the steel. Robots built for one task. Early days: several are contractors' own robots or still in development, but this is where site work is heading. Shimizu's Robo-Buddy fixes hangers and screws up ceiling boards from the BIM model; Shimizu's own sites, not sold. The catch: each does one job in set conditions, half aren't for sale, and almost none publish a price or output you can plan on.
Maker's figures
Finds its position by-Not publishedLaser sensor referencing BIM information, with imaging sensors to find the work spotMaker's figure
Buying it
PriceNot publishedNot sold; used on Shimizu's own sites.
ReleasedJun 20262018
MakerTMSUK Co., Ltd. · JapanShimizu Corporation · Japan
Every tick links to where we read it. “Not published” means the maker doesn’t say, not that it can’t. A maker’s figure is the maker’s claim, read at its source; we have not measured it. They are in alphabetical order, never by who pays.